Hello,
I wish to make a test of PLC programming too with the target on the VM. So I wish to have a separate network between the host and the VM.
I use:
VM workstation 9.0.3
Host Win 7 64 bits
Guest Win 7 32 bits
Network configuration:
Host IP 172.20.0.1 (VMnet1 adapter)
Guest IP 172.20.0.201
In the VM settings the adapter is set to host only.
In the virtual network editor the setting of IP adresses of the adapter VMnet1 is done accordingly to the above mentioned addresses.
When I run an ipconfig command on the host or on the guest the IP addresses are OK. I can ping the address 172.20.0.1 from guest but cannot ping 172.20.0.201 from the host. I also tried with removing the windows firewall on both side and got the same result. The antivirus of the guest is also turned off.
Does anybody have an idea ?
Many thanks for the attention.
Regards.
Marc